DMT LOGO

How to Tie Rein Ends or Water Loops to Reins

DMT LOGO

Rein ends, also known as water loops http://bit.ly/20fsiVp are short pieces of leather used to attach your reins to your bit with tie strings http://bit.ly/1n9YMBS. A rein end is attached to one side of each rein, looped through the bit ring and tied back to the opposite side of the rein. When a rein gets broken the tie string on the rein end will break or the rein will break in the hole the tie string was tied in which prevents a large section of your rein from breaking.

Rein ends are easy to attach to any rein. There are two knots that are routinely used: the square knot and the double loop knot. Follow along with the video and guideline below to learn how to attach rein ends using either of these knots.

  1. Working from outside to inside, thread each end of a latigo tie string (approximately ¼ inch wide x 16 inches long) evenly through both holes on one end of your water loop and then through the holes in the rein from the back. The knot in the tie strings should be facing out.
  2.  Loop the other end of the water loop through the bit ring. If the bit has a bit hobble put the water loop behind it.
  3. Thread the strings through the holes in the other side of the water loop and pull the strings tight.
    1. To tie the square knot lay the tie string end on the left over the tie string end on the right. Tuck the original left under the right and pull tight. Now lay the string on the right (this was the original left hand string) over the string on the left and tuck it under the left string. Pull the knot tight.
    2. To tie the double loop knot lay the tie string end on the left horizontally on the rein. Wrap the tie string end on the right under and over the left string twice, tightening the loop after each wrap. Make sure the loops are being made in the direction of the bit and not toward the tail of the rein. Pull the loops tight again after the second wrap.

Be sure to cut the same length of rein off of the opposite rein if you’ve broken one so the reins will stay even. Rein ends can be used on all types of leather split reins if the rein is strong and uncompromised by damage or holes in the rein.

Dennis Moreland makes harness leather reins and doubled and stitched reins by hand in various sizes and lengths to fit small and large horses. The reins are naturally weighted to have a beautiful drape. They are guaranteed and we believe they’ll be the best rein you’ve ever ridden! Check them out here: http://bit.ly/23fnJgl or call 817-312-5305 for more information. Rein Ends (water loops) are also available by clicking here: http://bit.ly/20fsiVp .

We’re a full line manufacturer of handmade tack and we’re here to help you!